REAM HMI Software for COILED TUBING Applications

 Version 1.24    08 February 2014 For G308 C000

Version 1.23    20 September 2011 For G308 C100

Version 1.32    13 March 2015 For G308 C100 

REAM HMI Software for PUMPING Services

 Version 1.30    10 February 2010

1. Ensure that you have a copy of all your system settings, such as Gains, Offsets, and K-Factors.

2. Ensure that the REAM HMI is switched off.

3. Remove the Compact Flash card. Ensure that you remember the card’s orientation, this will help you when re-inserting the card back into the HMI.

4. Insert the Compact Flash card into the card reader supplied with the system.

5. Connect the card reader to your computer (USB port).

6. Download the new software version by clicking the link above. Look for the latest version, download it to your computer and remember where you saved it.

7. The new software files will be packed together in a Zipped file. Extract all the files to the root folder of the Compact Flash.

8. Ensure that you stop the card reader, then disconnect the card reader from the computer.

9. Remove the Compact Flash card from the card reader and insert it back into the HMI.

10. Power up the HMI, you will see a message “Loading from CF”, wait until the system starts then wait for at least two minutes to allow the system to write to the Compact Flash.

11. Note that you may need to re-configure the system, for example, your old calibration data may be lost. Here, we deliberately say that you MAY need to re-configure the system because if the changes in the software are significant from the version that you already have, then there is a good chance that some of the settings will be lost.

This email address is being protected from spambots. You need JavaScript enabled to view it.